Lectrosonics DBSMD-B1C1 Dual-Battery Digital Transmitter/Recorder

  • Dual-battery digital transmitter and 24-bit recorder
  • Band B1C1: 537 to 691 MHz, 10 to 50 mW
  • Timecode jam sync and AES 256 encryption

$2,016.00 USD

Brand: Categories: , , Trew SKU: LEC.DBSMDB1C1 MPN: DBSMD-B1C1

Lectrosonics DBSMD-B1C1 Dual-Battery Digital Transmitter/Recorder

The Lectrosonics DBSMD-B1C1 is a dual-battery digital transmitter with a built-in recorder, developed for film production. It runs on two AA batteries and jams timecode for syncing its recordings.

This B1C1 model tunes from 537 to 691 MHz in 25 kHz steps. It transmits at 10, 25, or 50 mW, with a 2 mW high-density mode for very tight channel spacing. Choose frequencies that are approved for the region where the transmitter is used. Audio is encrypted with AES 256 in CTR mode, with four key policies.

Recording

The DBSMD records 24-bit, 48 kHz BWF files to a microSDHC card, about 23 hours on a 16 GB card. A temperature-compensated crystal holds timecode to better than 1 ppm after a jam. Models sold in the US stop the RF audio while recording, though battery status still reaches the receiver.

Input and Setup

The TA5M input uses servo bias circuitry for electret lavaliers, dynamic mics, and line-level sources, with a fixed 5 V bias or a selectable 2 V or 4 V servo bias. A DSP-controlled analog limiter ahead of the first preamp protects the whole audio chain from overload. Gain adjusts in 1 dB steps, and the low-frequency roll-off sets at 20, 35, 50, 70, 100, 120, or 150 Hz. A two-way IR port speeds setup, and the control panel can be locked once it is set.

Build and Power

The housing is machined from solid aluminum for a light, rugged package, and its non-corrosive finish resists salt water and perspiration. Lithium AA cells are recommended, and one 40073 lithium AA comes in the box. It takes the same belt clips, pouches, and battery eliminators as the Lectrosonics SMDWB.

Features

  • Band B1C1: 537 to 691 MHz in 25 kHz steps
  • AES 256 CTR encryption with four key policies
  • 10, 25, or 50 mW output, plus a 2 mW high-density mode
  • 24-bit, 48 kHz recorder on a microSDHC card
  • Timecode jam sync with a TCXO, under 1 ppm
  • Servo bias TA5M input for lavs, dynamic mics, and line
  • Two-way IR port for fast setup
  • Lightweight, corrosion-resistant aluminum housing
  • Runs on two AA batteries

What's Included

  • 40073 AA lithium battery
  • AMM antenna
  • PSMDWB pouch
  • SMDWBBCSL belt clip with instructions (unmounted)
  • SMKITTA5 mic connector kit
  • 55010 16 GB microSD card
  • 35924 foam insulating pads (2)
  • SM silver paste
  • Quick start guide

Specifications

RF
Operating Frequencies Band B1C1: 537 to 691 MHz
Frequency Steps 25 kHz
RF Power Output 2 mW (HDM only), 10, 25, or 50 mW
Compatibility Modes D2 digital with encryption; HDM high-density digital with encryption
Modulation Type 8PSK
Encryption AES-256 in CTR mode
Frequency Stability ±0.002%
Antenna Flexible, unbreakable steel cable
Audio Input
Input Type Analog mic/line level; servo bias preamp for 2 V and 4 V lavaliere microphones
Input Connector TA5M 5-pin male
Input Level Dynamic mic: 0.5 mV to 50 mV; electret lavaliere: 1.7 to 170 µA; line level: 17 mV to 1.7 V (before limiting)
Input Impedance Dynamic mic: 300 ohms; electret lavaliere: virtual ground with servo adjusted constant current bias
Bias Voltage Fixed 5 V at up to 5 mA; selectable 2 V or 4 V servo bias
Input Limiter Soft limiter, 30 dB range
Equivalent Input Noise −125 dBV, A-weighted
Low-Frequency Roll-Off Adjustable from 20 to 150 Hz (20, 35, 50, 70, 100, 120, 150 Hz)
Modulation Indicators Dual bicolor LEDs (−20, −10, 0, +10 dB)
Audio Performance
Frequency Response 20 Hz to 20 kHz, ±1 dB (D2 mode); 20 Hz to 16 kHz, ±3 dB (HDM mode)
Dynamic Range 112 dB (A)
Distortion <0.035%
Recorder
Storage Media microSDHC memory card
File Format .wav files (BWF)
A/D Converter 24-bit
Sampling Rate 48 kHz
Recording Mode HD mono, 24-bit, 144 kbytes/s
Recording Time 8 GB: 11:10; 16 GB: 23:00; 32 GB: 46:10 (hours:minutes, approx.)
Timecode Jam sync, TCXO, <1 ppm accuracy
Power and Environment
Battery 2 x AA (+1.5 VDC), disposable; lithium recommended
Operating Temperature −20 to 40 °C (−5 to 104 °F)
Scroll to Top

The manufacturer limits where we can sell this product.

North America: No restrictions. U.S. and Canadian orders see live shipping rates for their respective regions at checkout.

Outside North America: We can’t ship this product, and checkout won’t accept an address outside North America for orders that include this product.