Lectrosonics DBSM-B1C1 Digital Transmitter with Recorder
The Lectrosonics DBSM-B1C1 is a digital transmitter with a built-in recorder, developed for film production. It runs on a single AA battery and jams timecode for syncing its recordings.
This B1C1 model tunes from 537 to 691 MHz in 25 kHz steps. It transmits at 10, 25, or 50 mW, with a 2 mW high-density mode for very tight channel spacing. Choose frequencies that are approved for the region where the transmitter is used. Audio is encrypted with AES 256 in CTR mode, with four key policies.
Recording
The DBSM records 24-bit, 48 kHz BWF files to a microSDHC card, about 23 hours on a 16 GB card. A temperature-compensated crystal holds timecode to better than 1 ppm after a jam. Models sold in the US stop the RF audio while recording, though battery status still reaches the receiver.
Input and Setup
The TA5M input uses servo bias circuitry for electret lavaliers, dynamic mics, and line-level sources, with a fixed 5 V bias or a selectable 2 V or 4 V servo bias. A DSP-controlled analog limiter ahead of the first preamp protects the whole audio chain from overload. Gain adjusts in 1 dB steps, and the low-frequency roll-off sets at 20, 35, 50, 70, 100, 120, or 150 Hz. Audible tones allow hands-free setup and adjustment. The transmitter can sleep to save battery power while it is buried in costuming, then wake when production begins. A two-way IR port speeds setup.
Build and Power
The housing is machined from solid aluminum for a light, rugged package, and its non-corrosive finish resists salt water and perspiration. Lithium AA cells are recommended. It takes the same belt clips, pouches, and battery eliminators as the Lectrosonics SMWB.
Features
- Band B1C1: 537 to 691 MHz in 25 kHz steps
- AES 256 CTR encryption with four key policies
- 10, 25, or 50 mW output, plus a 2 mW high-density mode
- 24-bit, 48 kHz recorder on a microSDHC card
- Timecode jam sync with a TCXO, under 1 ppm
- Servo bias TA5M input for lavs, dynamic mics, and line
- Hands-free setup with audible tones, and a sleep mode
- Lightweight, corrosion-resistant aluminum housing
- Runs on one AA battery




