Deity Connect HD-TX Interview Kit
- HD-TX, BP-TX, and DUO-RX wireless kit
- Two sources to one camera or recorder
- Backup recorder in the HD-TX
$996.77 CAD
Deity Connect HD-TX Interview Kit
The Deity Connect interview kit pairs an HD-TX plug-on transmitter and a BP-TX bodypack transmitter with a DUO-RX dual-channel receiver, sending two sources over 2.4 GHz digital wireless to one camera or recorder.
The HD-TX plugs onto an XLR microphone, supplies +48 V phantom power, and records a 24-bit, 48 kHz WAV backup to microSD while it transmits. Its headphone jack monitors the recording and plays files back. Four safeguards protect the recording. The battery is built in, so it cannot fall out through an open battery door. When the unit is told to power down, it stops and saves the file, and the battery meter gives that command before the battery runs out. A lock screen keeps the buttons from being pressed by accident.
The BP-TX takes a locking 3.5mm lavalier and has a 1 in OLED display. It shares the HD-TX’s 10 to 100 mW RF settings, analog limiter, 75 Hz and 150 Hz low cut filters, and high-frequency boost.
The DUO-RX has two isolated channels, two true diversity antenna arrays for four antennas in all, and XLR, DSLR, and mono output modes. It controls each transmitter’s audio settings remotely. Its internal lithium battery runs about 10 hours and recharges over USB-C, and separate 1/4 in and 3/8 in threads underneath mount it to a camera or sound bag rig.
Features
- HD-TX plug-on transmitter with a built-in recorder
- BP-TX bodypack transmitter
- DUO-RX dual-channel receiver
- 2.4 GHz digital wireless
- +48 V phantom power on the HD-TX
- Lavaliers, cables, and a hard case included
What's Included
- HD-TX transmitter and recorder
- BP-TX transmitter
- DUO-RX dual-channel receiver
- HD-TX belt clip pouch
- 2 x USB-C cables
- USB-C to USB-A adapter
- 2 x lavalier microphones
- 3.5mm DSLR cable
- 2 x XLR cables
- Hard case
- Warranty card
- Manual
Specifications
| HD-TX | |
|---|---|
| Wireless Transmission | Digital 2.4 GHz, encrypted |
| Sample Rate | 48 kHz, 24-bit |
| Form Factor | Plug-on |
| RF Output Power | 10, 25, 50, or 100 mW (switchable) |
| Audio I/O | 1 x XLR 3-pin female balanced input (lockable) 1 × 3.5mm TRS female mic or line input (lockable) 1 × 3.5mm TRS female headphone output |
| Phantom Power | +48 V on the XLR input |
| Plug-In Power | 3 V on the 3.5mm input |
| Pad | Up to −12 dB |
| Gain Range | −12 to +36 dB |
| Signal Processing | High-pass filter: off, 20 to 200 Hz High-frequency boost: off, +1 to +10 dB at 7 kHz |
| Frequency Response | 20 Hz to 20 kHz |
| Antenna | 1/4 wave internal, fixed |
| Recording | 24-bit, 48 kHz WAV to microSD (up to 128 GB; SanDisk cards not compatible) |
| Power | Built-in rechargeable battery (2600 mAh) or USB bus power |
| Charge Time | 90 minutes |
| USB | 1 x USB-C (data transfer, charging, USB sound card) |
| Display | OLED, with mute, power, and pair LEDs |
| Operating Temperature | −10 to 45 °C (14 to 113 °F) |
| Dimensions | 42.5 × 112.3 × 42.5 mm (1.7 × 4.4 × 1.7 in) |
| Weight | 220 g (7.8 oz) |
