RF Venue Band-Pass Filters
- Multiple frequency ranges from 470 to 698 MHz
- 40 dB of rejection outside the band
- Hand-tuned
From $459.00 USD
RF Venue Band-Pass Filters
The RF Venue Band-Pass Filters keep out-of-band signals from saturating the front end of a wireless microphone receiver. That widens the receiver’s dynamic range and cuts noise and third-party interference in the frequency range you use.
Each hand-tuned filter connects in-line with a remote antenna through its BNC connectors and gives 40 dB of rejection outside its band. It needs no power and no configuration, and its footprint is only 3 x 1.75 inches.
A diversity system needs two filters, one for each antenna. They do not pass the DC bias an active antenna needs, and they are not for in-ear monitors or other transmitters.
Features
- Multiple frequency ranges from 470 to 698 MHz
- 40 dB of rejection outside the band
- Hand-tuned
- BNC connectors
- No power or configuration
- 3 x 1.75-inch footprint
Available Options
| Frequency Range | MPN | Works With |
|---|---|---|
| 470-530 MHz | BPF470T530 | Shure G50 and G1; Audio-Technica DE2 |
| 470-560 MHz | BPF470T560 | Shure G50 and H5; Sennheiser A and A1; Sennheiser 6000/9000 Low Band; Lectrosonics Blocks B19, B20, and B21 |
| 470-608 MHz | BPF470T608 | Most wireless microphones |
| 470-698 MHz | BPF470T698 | Most wireless microphones |
| 530-590 MHz | BPF530T590 | Shure H50; Audio-Technica EE1 |
Specifications
| Insertion Loss, Maximum | 3.5 dB |
|---|---|
| In-Band Ripple, Maximum | 1.5 dB |
| VSWR, Maximum | 1.5 |
| Power | 2 W |
| Operating Temperature | −30 to 70 °C |
| Connectors | BNC |
| Footprint | 7.6 × 4.5 cm / 3 × 1.75 in |
