Hollyland LARK M2S Wireless Lavalier Microphone System
The Hollyland LARK M2S pairs two 7 g wireless transmitters with receivers for cameras and phones and a charging case. Each transmitter has a titanium clip and no logo on the front.
Discreet Transmitters
The front of each transmitter measures 13 x 6.3 mm, so it sits small on a collar, and the titanium clip holds it in place through fast movement. A furry windshield comes with each transmitter for outdoor recording.
Sound and Noise Cancellation
The transmitters record at 48 kHz/24-bit with a signal-to-noise ratio above 70 dB and a maximum sound pressure level of 116 dB. One press of the noise cancellation button on a transmitter or receiver turns on ENC, which removes low-frequency noise, and the LarkSound app sets it to Strong or Weak.
The link reaches up to 1,000 feet (300 m) line of sight over 2.4 GHz adaptive frequency hopping. A circuit built to resist RF interference keeps the audio clean in office buildings, venues, and city streets.
Receivers and Power
The camera receiver has a 3.5 mm TRS output and a USB-C port, which can feed two recorders at once through an adapter cable. Its knob sets the volume, shown on LEDs, and switches mono or stereo. The USB-C and Lightning receivers plug into a phone and accept a charging cable that charges the phone. A setting in the app plays recordings back through the phone without unplugging the receiver.
Each transmitter runs about 9 hours and the camera receiver about 8.5 hours. The charging case brings the total to about 30 hours with a combo kit, or 27 hours with the Duo, and recharges the set in under 1.5 hours. The set comes paired from the factory. The Configurations tab compares the four kits.
Features
- Two 7 g transmitters with no front logo and a titanium clip
- 48 kHz/24-bit audio, over 70 dB SNR, and 116 dB maximum SPL
- One-press ENC with Strong and Weak levels in the LarkSound app
- Up to 1,000 feet (300 m) line of sight over 2.4 GHz
- Camera receiver with 3.5 mm and USB-C outputs and mono or stereo
- Plug-in USB-C and Lightning receivers, by kit
- About 9 hours per transmitter, and up to about 30 hours with the case
- Phone charging through the plug-in receiver’s USB-C port






















